SMC Networks SMC2890W-AN Management Manual page 129

Example
AP(config)# apmgmtui https server
AP(config)#
apmgmtui snmp
This command enables and disables SNMP management access to the AP.
Syntax
Default Setting
Enabled
Command Mode
Global Configuration
Example
AP(config)# apmgmtui snmp enable
AP(config)#
apmgmtip
This command specifies the client IP addresses that are allowed management
access to the access point through various protocols.
Note:
IP Management settings.
Syntax
■ The client and server establish a secure encrypted connection.
A padlock icon should appear in the status bar for Internet Explorer.
apmgmtui snmp [enable | disable]
enable - Enables SNMP management access.
disable - Disables SNMP management access.
Secure Web (HTTPS) connections are not affected by the UI Management or
apmgmtip [multiple <ip-address> <subnet-mask> | single <ip-address> | any]
multiple - Adds IP addresses within a specifiable range to the SNMP, web
and Telnet groups.
single - Adds an IP address to the SNMP, web and Telnet groups.
any - Allows any IP address access through SNMP, web and Telnet groups.
ip-address - Adds IP addresses to the SNMP, web and Telnet groups.
– 129 –
Chapter 11
| System Management Commands