Table of Contents
Advertisement
Default Setting
Percentage Mode: Full (100%)
dBm Mode: 18 dBm
Command Mode
Interface Configuration (Wireless)
Command Usage
◆
◆
Example
min-allowed-rate
This command selects minimum allowed transmit data rates for the AP.
Syntax
Default Setting
CCK Rate: 1 Mbps
OFDM Rate: 6 Mbps
Single Stream Rate: MCS0
Double Stream Rate: MCS8
Command Mode
Interface Configuration (Wireless)
The "min" keyword indicates minimum power.
The longer the transmission distance, the higher the transmission power
required. But to support the maximum number of users in an area, you must
keep the power as low as possible. Power selection is not just a trade off
between coverage area and maximum supported clients. You also have to
ensure that high strength signals do not interfere with the operation of other
radio devices in your area.
AP(if-wireless 0)# transmit-power percentage half
AP(if-wireless 0)#
min-allowed-rate {all | <cck-rate> <ofdm-rate> <singlestream-rate>
<doublestream-rate>}
all - Selects all available rates.
cck-rate - Specifies the minimum CCK rate (2.4 GHz radio only).
(Options: 1, 2, 5. 5, 11 Mbps)
ofdm-rate - Specifies the minimum OFDM rate.
(Options: 6, 9, 12, 18, 24, 36, 48, 54 Mbps)
singlestream-rate - Specifies the minimum 802.11n single stream rate.
(Options: MCS0, MCS1, MCS2, MCS3, MCS4, MCS5, MCS6, MCS7)
doublestream-rate - Specifies the minimum 802.11n double stream rate.
(Options: MCS8, MCS9, MCS10, MCS11, MCS12, MCS13, MCS14, MCS15)
– 211 –
Chapter 24
| Wireless Interface Commands
Advertisement
Table of Contents
