SMC Networks SMC2890W-AN Management Manual page 251

lldp-transmit hold-
muliplier
lldp transmit interval
This command configures the time-to-live (TTL) value sent in LLDP advertisements.
Syntax
lldp transmit hold-multiplier <multiplier>
multiplier - The hold multiplier number. (Range: 2-10)
Default Setting
4
Command Mode
Global Configuration
Command Usage
◆
This command configures the time-to-live (TTL) value sent in LLDP
advertisements as shown in the following formula:
(Transmission Interval * Hold time) ≤ 65536
Therefore, the default TTL is 4*30 = 120 seconds.
◆
The time-to-live tells the receiving LLDP agent how long to retain all
information pertaining to the sending LLDP agent if it does not transmit
updates in a timely manner.
Example
AP(config)# lldp transmit hold-multiplier 6
AP(config)#
This command configures the periodic transmit interval for LLDP advertisements.
Syntax
lldp transmit interval <interval>
interval - The time between LLDP advertisements.
(Range: 5-32768 seconds)
Default Setting
30 seconds
Command Mode
Global Configuration
Command Usage
This command configures the periodic transmit interval for LLDP advertisements.
This parameter must comply with the following rule:
(Transmission Interval * Hold Time) ≤ 65536, and
Transmission Interval >= (4 * Delay Interval)
Chapter 28
– 251 –
| Link Layer Discovery Commands