Table of Contents
Advertisement
shutdown (VAP)
This command disables the VAP interface. Use the no form to restart the interface.
Syntax
Default Setting
Interface enabled
Command Mode
Interface Configuration (Wireless-VAP)
Command Usage
You must first enable VAP interface 0 before you can enable VAP interfaces 1 to 15.
Example
AP(if-wireless 0: VAP[0])# shutdown
This setting has not been effective !
If want to take effect, please execute make-security-effective command !
AP(if-wireless 0: VAP[0])#
interfere-chan-
This command rescans channels when interference is detected on the current
recover
channel. Use the no form to disable the feature.
Syntax
Default Setting
Disabled
Command Mode
Interface Configuration (Wireless)
Command Usage
◆
◆
Example
AP(if-wireless 0)# interfere-chan-recover
AP(if-wireless 0)#
[no] shutdown
[no] interfere-chan-recover
When interference is detected on the current channel, the AP re-scans all
channels and then changes to a new clear channel.
There is too much interference on a channel when the AP is unable to send the
beacon signal more than ten times. The AP will then use its auto-channel
algorithm to find a new clear channel.
– 221 –
Chapter 24
| Wireless Interface Commands
Advertisement
Table of Contents
