System Logging Commands; Table 7: System Management Commands - SMC Networks SMC2890W-AN Management Manual

12
logging on

System Logging Commands

These commands are used to configure system logging on the access point.

Table 7: System Management Commands

Command Function
logging on Controls logging of error messages
logging host Adds a syslog server host IP address that will receive
logging messages
logging console Initiates logging of error messages to the console
logging level Defines the minimum severity level for event logging
logging clear Clears all log entries in access point memory
show logging Displays the state of logging
show event-log Displays all log entries in access point memory
This command controls logging of error messages; i.e., sending debug or error
messages to memory. The no form disables the logging process.
Syntax
[no] logging on
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to memory. You can use the
logging level command to control the type of error messages that are stored in
memory.
Example
AP(config)#logging on
AP(config)#
– 139 –
Mode Page
GC 139
GC 140
GC 140
GC 141
GC 141
142
Exec
Exec 142