General Commands - SMC Networks SMC2890W-AN Management Manual

10
configure

General Commands

This chapter details general commands that apply to the CLI.
Table 4: General Commands
Command Function
configure Activates global configuration mode
end Returns to previous configuration mode
exit Returns to the previous configuration mode, or exits the
CLI
cli-session-timeout Sets a timeout for CLI and Telnet sessions
ping Sends ICMP echo request packets to another node on the
network
reset Restarts the system
show line Shows the configuration settings for the console port
This command activates Global Configuration mode. You must enter this mode to
modify most of the settings on the access point. You must also enter Global
Configuration mode prior to enabling the context modes for Interface
Configuration. See "Using the Command Line Interface" on page
Default Setting
None
Command Mode
Exec
Example
AP#configure
AP(config)#
Related Commands
end
– 115 –
Mode Page
Exec 115
GC, IC 116
any 116
Exec 116
Exec 117
Exec 118
Exec 118
109.