Filtering Commands; Table 16: Filtering Commands - SMC Networks SMC2890W-AN Management Manual

20
filter local-bridge

Filtering Commands

The commands described in this section are used to filter communications
between wireless clients, control access to the management interface from wireless
clients, and filter traffic using specific Ethernet protocol types.

Table 16: Filtering Commands

Command Function
filter local-bridge Disables communication between wireless clients
filter restrict- Prevents wireless clients from accessing the
management management interface
filter dhcp Prevents wireless clients from accessing a DHCP
server
filter acl-source-address Configures ACL filtering based on source MAC
addresses
filter acl-destination- Configures ACL filtering based on destination MAC
address addresses
filter ethernet-type Checks the Ethernet type for all incoming and
enable outgoing Ethernet packets against the protocol
filtering table
filter ethernet-type Sets a filter for a specific Ethernet type
protocol
show filters Shows the filter configuration
This command disables communication between wireless clients. Use the no form
to disable this filtering.
Syntax
filter local-bridge <all-VAP | intra-VAP>
no filter local-bridge
all-VAP - When enabled, clients cannot establish wireless communications
with any other client, either those associated to the same VAP interface or
any other VAP interface.
intra-VAP - When enabled, clients associated with a specific VAP interface
cannot establish wireless communications with each other. Clients can
communicate with clients associated to other VAP interfaces.
Default
Disabled
– 179 –
Mode Page
GC 179
GC 180
GC 180
181
GC
GC 181
GC 182
GC 182
Exec 183