22
wds ap
wds sta
WDS Bridge Commands
The commands described in this section are used to set the operation mode for
each access point interface and configure Wireless Distribution System (WDS)
forwarding table settings.
Table 18: WDS Bridge Commands
Command
Function
wds ap
Selects the bridge operation mode for a radio
interface
wds sta
Configures the MAC addresses of the parent bridge
node
show wds wireless
Configures MAC addresses of connected child bridge
nodes
This command enables the bridge operation mode for the radio interface.
Syntax
wds ap
Default Setting
Disabled
Command Mode
Interface Configuration (Wireless) VAP
Example
AP(if-wireless 0 [VAP 0])#wds ap
AP(if-wireless 0 [VAP 0])#
This command configures WDS station mode on a VAP interface.
Syntax
wds sta ap-ssid <ssid> address <mac-address>
ssid - Severice set identifier. Maximum: 32 characters.
mac-address - The MAC address of the connecting VAP in WDS-AP mode.
– 197 –
Mode
Page
IC-W VAP
197
IC-W VAP
197
Exec
198