Link Integrity Commands; Table 23: Link Integrity Commands - SMC Networks SMC2890W-AN Management Manual

27
link-integrity

Link Integrity Commands

The access point provides a link integrity feature that can be used to ensure that
wireless clients are connected to resources on the wired network. The access point
does this by periodically sending Ping messages to a host device in the wired
Ethernet network. If the access point detects that the connection to the host has
failed, it disables the radio interfaces, forcing clients to find and associate with
another access point. When the connection to the host is restored, the access point
re-enables the radio interfaces.

Table 23: Link Integrity Commands

Command
link-integrity
link-integrity link-fail-action Sets the link fail action
show link-integrity
This command enables link integrity detection and configures the IP address,
detect interval, response timeout, and retry count for the link integrity host test.
Use the no form to disable link integrity detection.
Syntax
link-integrity [<ip_address> interval <interval> timeout <timeout>
retry <retry>]
no link-integrity
ip_address - IP address of the host.
interval - The interval time between each Ping sent to the host.
(Range: 10-86400 seconds)
timeout - The time to wait for a response to a Ping message.
(Range: 1-10 seconds)
retry - The number of consecutive failed Ping counts before the link is
determined as lost. (Range: 1-99)
Default Setting
Status: Disabled
Host IP Address: 192.168.2.254
Detect Interval: 60 seconds
Function
Enables link integrity detection and specifies
the IP address of a host device in the wired
network
Displays the current link integrity
configuration
– 247 –
Mode Page
GC 247
GC 248
Exec 249