SMC Networks SMC2890W-AN Management Manual page 192

Chapter 21
| Spanning Tree Commands
show bridge stp
show bridge br-conf
Command Mode
Global Configuration
Command Usage
The AP stores the MAC addresses for all known devices. All the addresses learned by
monitoring traffic are stored in a dynamic address table. This information is used to
pass traffic directly between inbound and outbound interfaces. When the MAC
address table "aging time" has expired, a learned MAC address is discarded from
the table.
Example
AP(config)# bridge mac-aging 300
AP(config)#
This command displays the global spanning tree settings for the bridge.
Syntax
show bridge stp
Command Mode
Exec
Example
AP#show bridge stp
Bridge STP Information
==================================
Bridge MAC
Status
priority
Hello Time
Maximum Age
Forward Delay
==================================
AP#
This command displays spanning tree settings for a specified VLAN.
Syntax
show bridge br-conf <all | vlan-id>
all - Keyword to show the STP configuration for all VLANs.
vlan-id - Specifies a VLAN ID. (Range: 0-4095)
Command Mode
Exec
: 00:12:CF:A2:54:30
: Disabled
: 32768
: 2 seconds
: 20 seconds
: 15 seconds
– 192 –