SMC Networks SMC2890W-AN Management Manual page 140

Chapter 12
| System Logging Commands
logging host
logging console
This command specifies syslog servers host that will receive logging messages. Use
the no form to remove syslog server host.
Syntax
logging host <1 | 2 | 3 | 4> <host_name | host_ip_address> [udp_port]
no logging host <1 | 2 | 3 | 4>
1 - First syslog server.
2 - Second syslog server.
3 - Third syslog server.
4 - Fourth syslog server.
host_name - The name of a syslog server. (Range: 1-20 characters)
host_ip_address - The IP address of a syslog server.
udp_port - The UDP port used by the syslog server.
Default Setting
None
Command Mode
Global Configuration
Example
AP(config)#logging host 1 10.1.0.3
AP(config)#
This command initiates logging of error messages to the console. Use the no form
to disable logging to the console.
Syntax
[no] logging console
Default Setting
Disabled
Command Mode
Global Configuration
Example
AP(config)#logging console
AP(config)#
– 140 –