System Clock Commands; Table 13: System Clock Commands - SMC Networks EliteConnect SMCE21011 User Manual

15
sntp-server ip
S C
YSTEM LOCK
These commands are used to configure SNTP and system clock settings on
the access point.

Table 13: System Clock Commands

Command Function
sntp-server ip Specifies one or more time servers
sntp-server Accepts time from the specified time
enable servers
sntp-server Manually sets the system date and time
date-time
sntp-server Sets the start and end dates for daylight
daylight-saving savings time
sntp-server Sets the time zone for the access point's
timezone internal clock
show sntp Shows current SNTP configuration
settings
This command sets the IP address of the servers to which SNTP time
requests are issued. Use the this command with no arguments to clear all
time servers from the current list.
S
YNTAX
sntp-server ip <1 | 2> <ip>
1 - First time server.
2 - Second time server.
ip - IP address of an time server (NTP or SNTP).
D S
EFAULT ETTING
137.92.140.80
192.43.244.18
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
When SNTP client mode is enabled using the sntp-server enable
command, the sntp-server ip command specifies the time servers from
which the access point polls for time updates. The access point will poll the
time servers in the order specified until a response is received.
– 148 –
C
OMMANDS
Mode
GC
GC
GC
GC
GC
Exec
Page
148
149
149
150
150
151