Table of Contents
Advertisement
Figure 40: WEP Configuration
The following items are on this page for WEP configuration:
◆
Default WEP Key Index – Selects the key number to use for encryption for the
VAP interface. If the clients have all four WEP keys configured to the same
values, you can change the encryption key to any of the settings without
having to update the client keys.
(Default: Key 1)
◆
Key Type – Select the preferred method of entering WEP encryption keys for
the VAP, either hexadecimal digits (Hex) or alphanumeric characters (ASCII).
◆
Key Length – Select 64 Bit or 128 Bit key length. Note that the same size of
encryption key must be supported on all wireless clients. (Default: 64 bit)
◆
Key – Enter up to four WEP encryption keys for the VAP.
Hex: Enter keys as 10 hexadecimal digits (0-9 and A-F) for 64 bit keys, or 26
■
hexadecimal digits for 128 bit keys.
ASCII: Enter keys as 5 alphanumeric characters for 64 bit keys, or 13
■
alphanumeric characters for 128 bit keys.
Note:
Key index, type, and length must match that configured on the clients.
– 81 –
Chapter 6
| Wireless Settings
Virtual Access Points (VAPs)
Advertisement
Table of Contents
