SMC Networks SMC2890W-AN Management Manual page 125

apmgmtui ssh port
apmgmtui telnet-
server enable
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
◆
The access point supports Secure Shell version 2.0 only.
◆
After boot up, the SSH server needs about two minutes to generate host
encryption keys. The SSH server is disabled while the keys are being generated.
The show system command displays the status of the SSH server.
Example
AP(config)# apmgmtui ssh enable
AP(config)#
This command sets the Secure Shell server port.
Syntax
apmgmtui ssh port <port-number>
port-number - The UDP port used by the SSH server.
(Range: 1-65535)
Default Setting
22
Command Mode
Global Configuration
Example
AP(config)# apmgmtui ssh port 1124
AP(config)#
This command enables the Telnet server. Use the no form to disable the server.
Syntax
apmgmtui telnet-server enable
no apmgmtui telnet-server
Chapter 11
– 125 –
| System Management Commands