Figure 44: Rogue Ap Detection - SMC Networks SMC2890W-AN Management Manual

Figure 44: Rogue AP Detection

The following items are displayed on this page:
◆
AP Scan Setting — Enables the periodic scanning for other nearby access
points. (Default: Disable)
◆
Scan Interval — Sets the time between each rogue AP scan. (Range: 15 -65535
seconds; Default: 7200 seconds)
◆
Scan Duration — Sets the length of time for each rogue AP scan. A long scan
duration time will detect more access points in the area, but causes more
disruption to client access. (Range: 10 -150 milliseconds; Default: 150
milliseconds)
◆
First Scan Delay — Delays the start of rogue AP scanning after enabling the
feature or booting the AP. (Range: 0 -65535 seconds; Default: 65535 seconds)
◆
Friendly AP — Allows you to enter the MAC address/Basic Service Set Identifier
(BSSID) of known APs in the network. These MAC addresses will be filtered out
of the list of detected APs during a scan.
◆
Friendly AP MAC Table — Displays the MAC addresses of known APs in the
network.
– 85 –
Chapter 6
| Wireless Settings
Rogue AP Detection