SMC Networks SMC2890W-AN Management Manual page 155

Example
Related Commands
snmp-server enable server
snmp-server trap
This command enables the access point to send specific SNMP traps
(i.e., notifications). Use the no form to disable specific trap messages.
Syntax
Default Setting
All traps enabled
Command Mode
Global Configuration
Command Usage
This command is used in conjunction with the snmp-server host and snmp-
server enable server commands to enable SNMP notifications.
Example
snmp-server vacm
This command configures SNMP v3 views. Use the no form to delete an SNMP v3
view view or remove a subtree from a filter.
Syntax
AP(config)#snmp-server host 1 10.1.19.23 batman
AP(config)#
snmp-server trap <trap>
no snmp-server trap <trap>
trap - One of the following SNMP trap messages:
sysSystemDown - The access point is about to shutdown and reboot.
sysSystemUp - The access point is up and running.
AP(config)#no snmp-server trap syssystemup
AP(config)#
snmp-server vacm view <name> [included | excluded] <subtree> [mask
<mask>]
no snmp-server vacm view <name> [included | excluded] <subtree>
name - A user-defined name that identifies an SNMP v3 view. (Maximum
length: 32 characters)
– 155 –
Chapter 15
| SNMP Commands