Vlan Commands; Table 25: Vlan Commands - SMC Networks SMC2890W-AN Management Manual

29
vlan

VLAN Commands

The access point can enable the support of VLAN-tagged traffic passing between
wireless clients and the wired network. VLAN IDs can be mapped to specific VAP
interfaces, allowing users to remain within the same VLAN as they move around a
campus site.
Caution: When VLANs are enabled, the access point's Ethernet port drops all
received traffic that does not include a VLAN tag. To maintain network connectivity
to the access point and wireless clients, be sure that the access point is connected
to a device port on a wired network that supports IEEE 802.1Q VLAN tags.
The VLAN commands supported by the access point are listed below.

Table 25: VLAN Commands

Command Function
vlan Enables a single VLAN for all traffic
management-vlanid Configures the management VLAN for the access point
native-vlanid Configures the default VLAN for the LAN port
vlan-id Configures the default VLAN for the VAP interface
This command enables VLANs for all traffic. Use the no form to disable VLANs.
Syntax
vlan enabled
no vlan
Default
Disabled
Command Mode
Global Configuration
Command Description
◆
When VLANs are enabled, the access point tags frames received from wireless
clients with the VAP's default VLAN ID.
– 254 –
Mode Page
254
GC
GC 255
GC 256
IC-W- 256
VAP