Common Web Page Buttons; Figure 3: Set Configuration Changes - SMC Networks SMC2890W-AN Management Manual

Common Web Page
Buttons
The web interface Main Menu menu provides access to all the configuration
settings available for the AP.
To configure settings, click the relevant Main Menu item. Each Main Menu item is
sumarized below with links to the relevant section in this guide where
configuration parameters are described in detail:
◆
System — Configures Management IP, WAN, LAN and QoS settings. See
"System Settings" on page
◆
Administration — Configures HTTP, Telnet, and SSH access settings. See
"Management Settings" on page
◆
Advanced — Confiures LLDP and Access Control Lists. See
on page 60.
◆
Wireless — Configures AP radio settings. See
◆
SNMP — Configures SNMP settings. See
◆
Maintentance — Enables firmware upgrades and resets the AP. See
"Maintenance Settings" on page
◆
Information — Displays current system settings. See
page 97.
The list below describes the common buttons found on most web management
pages:
◆
Set – Applies the new parameters and saves them to temporary RAM memory.
Also displays a screen to inform you when it has taken affect. Clicking 'OK'
returns to the home page. The running configuration will not be saved upon a
reboot unless you use the "Save Config" button.

Figure 3: Set Configuration Changes

◆
Cancel – Cancels the newly entered settings and restores the originals.
◆
Help – Displays the help window.
33.
49.
"Management Settings" on page
91.
– 22 –
Chapter 1
| Introduction
Connecting to the Web Interface
"Advanced Settings"
"Wireless Settings" on page
"Status Information" on
67.
49.