Table of Contents
Advertisement
Chapter 4
| Management Settings
Simple Network Management Protocol
SNMPv3 Notification
Filters
Figure 25: SNMPv3 Targets
The following items are displayed on this page:
◆
Target ID — A user-defined name that identifies a receiver of notifications.
(Maximum length: 32 characters)
◆
IP Address — Specifies the IP address of the receiving management station.
◆
UDP Port — The UDP port that is used on the receiving management station
for notification messages.
◆
SNMP User — The defined SNMP v3 user that is to receive notification
messages.
◆
Notification Filter — The name of a user-defined notification filter that is
applied to the target.
SNMP v3 users can be configured to receive notification messages from the access
point. An SNMP Target ID is created that specifies the SNMP v3 user, IP address, and
UDP port. A user-defined notification filter can be created so that specific
notifications can be prevented from being sent to particular targets.
Figure 26: SNMP Notification Filter
– 58 –
Advertisement
Table of Contents
