LED Indicators
The EZ Connect Wireless Access Point includes three status LED
indicators, as described in the following figure and table.
LED
Power (PWR)
Wireless
Link
Ethernet LNK
System Requirements
Before you install the EZ Connect Wireless Access Point, be sure you have
met the following requirements:
•
An AC power outlet (100~240 V, 50~60 Hz)
•
An available RJ-45 (UTP) port on an Ethernet hub or switch
•
802.11b compliant wireless Ethernet adapters with TCP/IP protocols
installed
Status
On (Red)
TX
Flashing (Green)
RX
Flashing (Green)
On (Orange)
ACT
Flashing (Orange)
Description
Power is being supplied.
The Access Point is transmitting data through
wireless links.
The Access Point is receiving data through
wireless links.
Valid Ethernet cable link.
The Access Point is transmitting or receiving
data on the Ethernet LAN
LED I
NDICATORS
5