System Logging Commands; Table 10: System Management Commands - SMC Networks E21011 User Manual

14
logging on
S L
YSTEM OGGING
These commands are used to configure system logging on the access
point.

Table 10: System Management Commands

Command Function
logging on Controls logging of error messages
logging host Adds a syslog server host IP address that will receive
logging messages
logging console Initiates logging of error messages to the console
logging level Defines the minimum severity level for event logging GC
logging clear Clears all log entries in access point memory
show logging Displays the state of logging
show event-log Displays all log entries in access point memory
This command controls logging of error messages; i.e., sending debug or
error messages to memory. The no form disables the logging process.
S
YNTAX
[no] logging on
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
The logging process controls error messages saved to memory. You can
use the logging level command to control the type of error messages that
are stored in memory.
E
XAMPLE
AP(config)#logging on
AP(config)#
– 137 –
C
OMMANDS
Mode Page
GC 137
GC 138
GC 138
139
GC 139
Exec 140
Exec 140