System Logging Commands; Log - HP 530 Management Manual

System Logging Commands

These commands are used to configure system logging on the access point.
Command Function

log

Displays all log entries in access point memory.
[no] logging Adds a syslog server host IP address and assign a port
<syslog_host> number that will receive logging messages.
[syslog_port]
show debug Displays the debugging results.
show logging Displays the state of logging.
log
This command displays all the entries in the event log on the device. This
command is functionally the same as the show logging command.
Syntax
log
Default Setting
N/A
Command Mode
Manager Exec
Command Line Reference

System Logging Commands

Mode Page
MC 9-31
GC 9-32
MC 9-33
MC 9-33
9-31