1.
Click Management > SNMP and select the Traps tab.
2.
Under the Trap Groups, check or uncheck the required traps boxes.
Click Update.
3.
SNMP Trap Hosts
The SNMP – Trap Hosts screen allows configuration of the following SNMP
trap parameters:
Trap Destination Host (1 to 3): Enables/Disables recipients (up to
■
three) of SNMP notifications. For each destination, enter the IP address
or the host name, and the community name.
■
IP Address: Specifies the IP address or the host name (from 1 to 20
characters) for the recipient of SNMP notifications.
■
Community Name: The community string sent with the notification
operation. (Maximum length: 32 characters)
[Update]: Updates the Trap settings.
■
Figure 5-7. Configuring SNMP Trap Destinations
To Configure SNMP Trap Destinations:
1.
Click Management > SNMP and select the Trap Hosts tab.
To set trap destinations, click Trap Destination Host 1, 2, or 3.
2.
General System Configuration
Configuring SNMP
5-35