Hostname - HP 530 Management Manual

Command Line Reference
System Management Commands
9-20
• The access point's Country Code must be set before the radio can be
enabled.
• After a Country Code has been set and the system rebooted, the
country command is no longer available from the CLI. If you need to
change the Country Code, the access point configuration must be
reset to its default values by using the erase-startup-config
command, or by pressing the reset button and clear buttons simulta-
neously, see Appendix A,
on page A-17.
Example
ProCurve Access Point 530# country gb
ProCurve Access Point 530#

hostname

This command sets the system hostname.
Syntax
hostname <hostname>
• hostname - A text string to identify the system.
(Maximum length: 50 characters)
Default Setting
ProCurve-AP-530
Command Mode
Global Configuration
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# hostname Gary
"Resets the configuration back to factory defaults."