Cli: Setting The Transmit Power Reduction And Antenna Parameters - HP 530 Management Manual

Wireless Interface Configuration
Modifying Antenna Settings
6-26
CLI: Setting the Transmit Power Reduction and Antenna
Parameters
CLI Commands Used in This Section
Command Syntax
tx-power-reduction <value>
antenna <external | internal>
antenna mode <diversity | single>
show radio
The following example shows how to set the transmit power reduction value,
establish an external antenna, and set the mode to Single on the access point.
The default mode is set to Diversity.
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# tx-power-reduction 5
ProCurve Access Point 530(radio1)# antenna external
ProCurve Access Point 530(radio1)# antenna mode single
CLI Reference Page
9-115
9-106
9-106
9-117