Cli: Setting The Radio Working Mode - HP 530 Management Manual

N o t e
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# show radios
Radio Status
-----------------------------------------------------------------------
1 Enabled
2 Enabled
ProCurve Access Point 530(config)#

CLI: Setting the Radio Working Mode

CLI Commands Used in This Section
Command Syntax
radio <radio_name>
mode<mode>
show radios <radio>*
*Use the parameter <radio> to display
detailed information about the specified
radio.
The following example shows how to enable the radio context level on a
specific radio and set the working mode for the access point to 802.11g-only
mode.
Enter radio commands, one per line.
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# mode g
ProCurve Access Point 530(radio1)#
The following example uses the show radios command to display current
details on the dual radios configured on the access point.
Base MAC Address
00:14:C2:A7:11:A0
00:14:C2:A7:E1:20
CLI Reference Page
9-102
9-105
9-117
Mode Channel
802.11g 11 - Auto
802.11g 11 - Auto
Wireless Interface Configuration
Configuring the Radio
Max Power
0.0 dBm
20.0 dBm
6-11