HP 530 Management Manual page 185

Command Syntax
<name>
[no] atpc rf-group-name
atpc adapt < ap | ap+clients >
<max-reduction>
atpc max-atpc-atten
show atpc
The following example refers to the use case described in "Airport Case 2 –
With RF Group Name" on page C-5. To configure AP #1 in this use case, enter
the following commands:
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# atpc adapt ap
ProCurve Access Point 530(radio1)# atpc max-reduction 18
ProCurve Access Point 530(radio1)# atpc rf-group-name
AirportNet
ProCurve Access Point 530(radio1)#
ProCurve Access Point 530(radio1)# show atpc
Radio 1
-------
atpc:
RF Group name:
Avoid Other WLANs:
Max Power Reduction:
Adaptive Mode:
Current Beacon Backoff:
Current Data Backoff:
Radio 2
-------
atpc:
RF Group name:
Avoid Other WLANs:
Max Power Reduction:
Adaptive Mode:
Current Beacon Backoff:
Current Data Backoff:
ProCurve Access Point 530(radio1)#
Wireless Interface Configuration
CLI Reference Page
9-143
9-144
9-145
9-145
enabled
AirportNet
disabled
18
AP
4 dB
4 dB
disabled
<not configured>
disabled
18
AP
0 dB
0 dB
Adaptive Tx Power Control
6-33