System Status Led; Led Display Settings - HP 500R Series Installation Manual

1
2
LEDs
The LEDs located on the front panel of the access point indicate the system and radio status of the access
point.

System Status LED

The system status LED indicates the system status of the access point.
Table 1: System Status LED
Color/State
Off
Green - blinking
Green - solid
Red
Radio Status LED
The radio status LED indicates the radio status of the access point.
Table 2: Radio Status LED
Color/State
Off
Green- solid
Green- blinking
Amber- solid
Amber- blinking
Alternating green/amber
1. Blinking: one second on, one second off, 2 seconds cycle.
2. Alternating: one second each color, 2 seconds cycle.

LED Display Settings

The LEDs have three operating modes that can be selected in the system management software:
Normal mode: default after power on. Refer to
n
Off mode: the LEDs are all off
n
Blink mode: both LEDs blink green (synchronized)
n
Rev 02 | May 2023
USB Micro-B Console Port (proprietary)
Reset Button
Meaning
Access point powered off
1
Access point booting, not ready
Access point ready, fully functional
System error condition - Immediate attention required
2
Meaning
Device powered off, or both radios disabled
Both radios enabled in access mode
One radio enabled in access mode, the other disabled
Both radio enabled in monitor mode
One radio enabled in monitor mode, the other disabled
One radio enabled in access mode, the other in monitor mode
Table 1 and Table 2.
| 3