Command Line Reference
General Commands
9-10
General Commands
These commands are used to configure the basic commands on the access
point.
Command
Function
configure
Set the current context level to the Global
Configuration level.
copy
See "Flash/File Commands" on page 9-50
end
Sets the current context level to the Manager
Exec level.
erase
See "Flash/File Commands" on page 9-50
exit
Sets the current command level to the
previous command level.
log
See "System Logging Commands" on
page 9-31
logout
Terminates the CLI session.
ping
Sends ICMP echo request packets to another
node on the network
reload
Perform a warm reboot.
Show
Show operation information and parameters
for this device.
terminal
Sets dimensions of the terminal window.
write
See "Flash/File Commands" on page 9-50
configure
This command activates Global Configuration mode. You must enter this
mode to modify most of the settings on the access point. You must also enter
Global Configuration mode prior to enabling the context modes for Interface
Configuration.
See "Using the CLI" on page 3-6.
Mode
Page
MC
9-10
9-51
MC
9-11
9-54
MC
9-11
9-31
MC
9-12
MC
9-13
MC
9-14
MC
9-14
MC
9-16
9-55