Cli: Setting Basic Snmp Parameters - HP 530 Management Manual

General System Configuration
Configuring SNMP
5-28
To Enable SNMP and Set Parameters:
1. Click Management > SNMP and select the Settings tab.
2. To activate SNMPv1/v2 features on the access point, click the SNMPv1/
v2 Enabled button.
3. To establish a public read-only SNMP community, enter a name text string
to replace the default community name (public) in the Community Name
(RO) field.
4. To establish a private read-write SNMP community, enter a name text
string to replace the default community name (private) in the Community
Name (R/W) field.
5. To activate SNMPv3 security features on the access point, click the
SNMPv3 Enabled button.
6. Enter a port value in the Port field.
Select [Update].
7.

CLI: Setting Basic SNMP Parameters

CLI Commands Used in This Section
Command Syntax
[no] snmp-server community <comm> restricted |
unrestricted
snmp-server port <port>
[no] snmp-server host <host>|<comm>
[no] snmp-server trap <trap>
show snmp-server
CLI Reference Page
9-38
9-42
9-40
9-43
9-45