HP 530 Management Manual page 207

Configuring Encryption in the ProCurve Wireless Access Point 530
Encryption Methods and
Process
No Security
Static WEP Keys:
1. Enable WEP Security.
2. Set the Key Index,
Length, and Type.
3. Configure the Keys.
4. Set the Authentication.
Dynamic WEP:
1. Enable Dynamic WEP
Security.
2. Set the Authentication
Server and Protocol.
3. Set RADIUS Key.
When you have decided which security mechanisms to implement in your
network, refer to Table 7-2 and Table 7-3 for a summary of the access point
configuration procedures.
For more details on security configurations that are possible using the CLI,
see
"CLI: Configuring Security Settings" on page
Table 7-2. Summary of Wireless Security Configuration
WLAN Interface Level Commands
security <no security>
security <static-wep>
wep-default-key <1| 2| 3| 4>
[no] wep-key ascii
wep-key-length <64|128>
wep-key <1| 2| 3| 4> <string>
[no] open-system-authentication
[no] shared-key authentication
security <dynamic-wep>
radius-accounting <primary | secondary> <ip
<ip> | port <port> | key <key>>
radius <primary | secondary>
*The radius-key value is used with an external
RADIUS server only and is ignored for the
internal radius server. It should be set to the
shared secret key that is configured on the
external RADIUS server.
Wireless Security Configuration
Wireless Security Overview
7-24.
Additional Notes
Requirements
WEP supported Requires manual key
station required. management.
Encryption index, length,
and type configured in
the access point must
match those configured
in the stations.
RADIUS server The built-in
required. authentication server
can be used on the
802.1X
access point or on an
supplicant
external RADIUS server.
required.
To use the built-in
WEP supported
authentication server,
station required.
set the RADIUS IP
address to that used by
the built-in server, and
turn RADIUS accounting
off (because it is not
supported by the built-in
server).
7-13