Configuring G- Only Mode - HP 530 Management Manual
Procurve wireless access point 530
Hide thumbs
Also See for 530:
- Maintenance and service manual (138 pages) ,
- Specification (19 pages) ,
- Handbook (95 pages)
Table of Contents
Advertisement
Configuring G- Only Mode
Figure 6-6. Configuring Wi-Fi G-Only Mode
To Configure Wi-Fi G-Only Mode:
This setting, shown in Figure 6-6, allows g-only stations to associate with the
AP. This is Wi-Fi standard-based g-only mode.
1.
Select Network Setup > Radio tab > IEEE 802.11g mode >
Advanced Settings.
2.
Select Enable for Protected Mode, to set this radio parameter.
3.
Select rate set values (24, 12, and 6), using the Basic options.
4.
Select
[Update]
to set the advanced radio parameters.
Wireless Interface Configuration
Configuring the Radio
[Edit]
>
6-19
Hide quick links:
Advertisement
Chapters
Table of Contents
