Beacon-Interval - HP 530 Management Manual

Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# channel-policy static 1
ProCurve Access Point 530(radio1)#

beacon-interval

This command configures the rate at which beacon frames are transmitted
from the access point. See
cast/multicast rates and burst values (in packets per second).
Syntax
beacon-interval <value>
value - The rate for transmitting beacon frames.
•
(Range: 20-2000 microseconds)
Default Setting
100. The default behavior is to send a beacon frame once every 100
microseconds (or 10 per second).
Command Mode
Radio Interface Configuration
Command Usage
The beacon frames allow wireless stations to maintain contact with the
access point. They may also carry power-management information.
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# beacon-interval 150
Related Commands
rate-limit (page 9-158)
(page 9-158) syntax for setting the broad-
rate-limit
Command Line Reference
Wireless Interface Commands
9-109