Command Line Reference
Adaptive Tx Power Control Commands
9-144
Default Setting
Disabled
Command Mode
Interface Configuration (Radio)
Command Usage
•
When an RF Group Name is specified, adapts only to other APs on
the same channel that have the same RF Group Name assigned.
•
When no RF Group Name is specified, adapts to other APs according
to a comparison of their respective SSID lists.
Example
ProCurve Access Point 530(radio1)# atpc rf-group-name
AirportNet
ProCurve Access Point 530(radio1)#
atpc adapt
This command chooses between AP and AP + Clients adaptive modes.
Syntax
atpc adapt < ap | ap+clients >
ap - Specifies AP adaptive mode on the selected radio.
•
ap+clients - Specifies AP + Clients adaptive mode on the selected
•
radio.
Default Setting
AP mode.
Command Mode
Interface Configuration (Radio)
Command Usage
When ap mode is selected, beacons and data transmissions are given
•
the same adaptive transmit power levels.
•
When ap+clients is selected, beacons are transmitted at maximum
power, while data is transmitted at adaptive power levels.