N o t e
CLI: Setting the System Name
CLI Commands Used in This Section
Command Syntax
hostname <hostname>
show system-information
The following example shows using the hostname <hostname> syntax to set
the name of the system.
Enter management commands, one per line.
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# hostname ProCurve-AP530
ProCurve Access Point 530(config)#
To display the configured system name, use the show system-information
command.
General System Configuration
Modifying System Information
CLI Reference Page
9-20
9-28
5-17