Web: Configuring Access Controls - HP 530 Management Manual

General System Configuration
Setting Management Access Controls
N O T E
5-10

Web: Configuring Access Controls

The AP Access screen configures access to management interfaces and
button.
The Web interface enables you to modify these parameters:
CLI Access
■ Serial Interface: Enables or disables management access through the
access point's serial console port. (The default is Enabled.)
You can not disable the serial interface, if you already have disabled the
Factory Reset option.
■ Telnet Interface: Enables or disables management access through
Telnet. (The default is Enabled.)
■ SSH Interface: Enables or disables management access through a
Secure Shell version 2.0 client. (The default is Enabled.)
Web Access
HTTP Interface: Enables or disables management access through and
■
HTTP interface . (The default is Enabled.)
■ SSL Interface: Enables or disables management access through an SSL
interface. (The default is Enabled.)
Button Access - For managing button access see,
Push Buttons" on page A-18.
■ Factory Reset: Enables or disables button control access (back panel of
the access point) to a factory default file reset. (The default is Enabled.)
Custom Reset: Enables or disables button control access (back panel of
■
the access point) to a custom config file reset. (The default is Enabled.)
■ System Reset: Enables or disables button control access (back panel of
the access point) to a system reset. (The default is Enabled.)
"Disabling the Access Point