Telnet Access; Secure Shell Access - HP 530 Management Manual

When correctly connected to the access point, press
console session.
For more information on connecting to the access point's Console port, refer
to the Installation and Getting Started Guide.
N o t e
The default Static IP address is 192.168.1.10. If there is no DHCP server on the
network, the access point retains this static IP address at first-time startup.

Telnet Access

To configure the access point through a Telnet session, make sure the access
point is configured with an IP address and that it is reachable from the PC that
is running the Telnet session (for example, use a ping command to the access
point's IP address).
Start the Telnet program on the PC using the access point's IP address (or DNS
name).

Secure Shell Access

Configuring the access point through an SSH client provides a secured connec-
tion as traffic is encrypted.
To configure the access point through an SSH session, make sure the access
point is configured with an IP address and that it is reachable from the PC that
is running the SSH session (for example, use a ping command to the access
point's IP address).
Start the SSH program on the PC using the access point's IP address (or DNS
name).
After boot up, the SSH server needs about two minutes to generate host
encryption keys. The SSH server is disabled while the keys are being gener-
ated.
For more information on the Secure Shell, see
Controls" on page
telnet 10.11.12.195
[Enter]
telnet AP530
[Enter]
ssh 10.11.12.195
[Enter]
ssh AP530
[Enter]
5-9.
Using the Command Line Interface (CLI)
[Enter]
Example of an IP address.
Example of a DNS-type name.
Example of an IP address.
Example of a DNS-type name.
"Setting Management Access
Accessing the CLI
to initiate the
3-5