Snmp-Server Port - HP 530 Management Manual

Command Line Reference
Network Management Application Commands
9-42

snmp-server port

This command specifies the port number that the SNMP server will use on
this device.
Syntax

snmp-server port

<port>
• port - The number specifying the port to which the SNMP server will
listen. This must be an unused port on the AP.
Default Setting
161
Command Mode
Global Configuration
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# snmp-server port 161
ProCurve Access Point 530(config)#