Ap Authentication Commands; Ap-Authentication - HP 530 Management Manual

Command Line Reference

AP Authentication Commands

9-86

AP Authentication Commands

The command described in this section is used to enable and configure AP
Authentication in the Access Point 530.
Command
[no] ap-authentication
show ap-authentication

ap-authentication

This command enables and configures AP Authentication on the device. The
no version of the command disables AP Authentication for the device.
Syntax
[no] ap-authentication <username> <password>
username - Specifies the "user" name of the access point.
•
password - Specifies the password for the access point "user".
•
[no] ap-authentication eap-type <eap-type>
eap-type - Specifies the EAP authentication type for the access point
•
"user" (either MD5 or PEAP).
Default
Disabled
Command Mode
Global Configuration
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# ap-authentication AP2167
21B83j0k
ProCurve Access Point 530(config)# ap-authentication eap-
type peap
ProCurve Access Point 530(config)#
Function
Enables and disables AP authentication on
the access point.
Displays the current AP Authentication
settings.
Mode Page
GC 9-86
GC 9-87