Cli: Modifying Wlan (Bss/Ssid) Interface Settings - HP 530 Management Manual

ProCurve Access Point 530(radio1-wlan1)# show wlan 1
WLAN #1 on Radio 1
Description Radio 1 - WLAN 1
Status Enabled
VLAN 1
DTIM Period 2
Security Type no-security (No Sec.)
MAC Auth Mode local deny-list only
Authentication open-system only
WEP Key 1 akshjsnensitk
......
- Untagged

CLI: Modifying WLAN (BSS/SSID) Interface Settings

CLI Commands Used in This Section
Command Syntax
ssid <SSID>
description <description>
disable | enable
vlan <vid>
closed-system
show wlan <index >
The following example shows how to modify WLAN interface settings.
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# wlan 1
ProCurve Access Point 530(radio1-wlan1)# disable
ProCurve Access Point 530(radio1-wlan1)# description unsecure
ProCurve Access Point 530(radio1-wlan1)# vlan 9
ProCurve Access Point 530(radio1-wlan9)# closed-system
ProCurve Access Point 530(radio1-wlan9)
Managing Multiple WLAN (BSS/SSID) Interfaces
SSID PR3_WLAN
BSSID 00:14:C2:A7:11:A0
Closed System
MAC Auth List
WEP Key Type
WEP Key Size
CLI Reference Page
9-103
9-103
9-103
9-103
9-103
9-103
Wireless Interface Configuration
Disabled
not set
ascii
128bit
6-39