Wds-Ssid; Radio-Used - HP 530 Management Manual

Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# interface wds1
ProCurve Access Point 530(wds1)# enable
ProCurve Access Point 530(wds1)#

wds-ssid

This command sets the WDS SSID string for this WDS link. This command is
only used for the wpa-psk security mode only.
Syntax
wds-ssid <ssid>
ssid - The text string that specifies the SSID of the interface.
•
(1 - 32 alphanumeric characters).
Note: When using WPA over WDS, an SSID is required and must match
the SSID on the WDS partner access point for successful operation.
Default Setting
WDS SSID X, where X is the index of the WDS interface.
Command Mode
WDS Interface Configuration
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# interface wds1
ProCurve Access Point 530(wds1)# wds-ssid marge
ProCurve Access Point 530(wds1)#

radio-used

This command sets the radio used with this WDS link.
Syntax
radio-used <1 | 2>
1 | 2 - Specifies the radio number.
•
Command Line Reference
Wireless Distribution System (WDS)
9-161