Command Line Reference
Adaptive Tx Power Control Commands
9-142
Adaptive Tx Power Control Commands
The commands described in this section configure parameters for Adaptive
Tx Power Control.
Command
[no] atpc
[no] atpc avoid-other-aps
[no] atpc rf-group-name
<name>
atpc adapt < ap | ap+clients >
<max-
atpc max-reduction
reduction>
show atpc
atpc
This command enables and disables Adaptive Tx Power Control on the
selected radio.
Syntax
[no] atpc
no - Disables on the selected radio.
•
Default Setting
Disabled
Command Mode
Interface Configuration (Radio)
Function
Enables and disables Adaptive Tx
Power Control on the selected radio.
(The default is Disabled.)
Enables and disables the Avoid Other
APs function. (The default is Disabled.)
The name used to group APs for
Adaptive Transmit Power Control. (The
default is blank.)
Chooses between AP mode and
AP + Client mode.
The maximum amount of power
attenuation, from 0-18dB. (The default
is 18dB.)
Shows the current settings for ATPC.
Mode
Page
IC-R
9-142
IC-R
9-143
IC-R
9-143
IC-R
9-144
IC-R
9-145
GC
9-145