Command Line Reference
Spanning Tree Protocol (STP)
9-166
Spanning Tree Protocol (STP)
The STP commands supported by the access point are listed below.
Command
[no] stp [hello-time <value>] [forward-
delay <value>] [priority <value>]
stp
This command configures Spanning Tree Protocol settings for the device. The
no version of the command disables STP on the device.
Syntax
stp [hello-time <value>] [forward-delay <value>] [priority <value>]
no stp
hello-time <value> - Specifies the STP hello time interval. (Range 1-10).
•
•
forward-delay <value> - Specifies the STP forward delay interval.
(Range 4-30)
priority <value> - Specifies the STP bridge priority. (Range 0-65535)
•
Default Setting
None
Command Mode
Global Configuration
Command Usage
•
Any two access points can be connected by only a single path; either
a WDS bridge (wireless) or an Ethernet connection (wired), but not
both.
•
Do not create duplicate WDS links between the same two access
points.
•
If you can trace more than one path between any pair of APs going
through any combination Ethernet or WDS links, you have a loop.
Function
Sets stp parameters for this
device.
Mode
Page
GC
9-166