Ipv6 Pim Timer Join-Prune - HP 6125XLG Command Reference Manual

undo ipv6 pim timer hello
Default
The hello interval is 30 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
interval: Sets the interval (in seconds) for sending hello messages, in the range of 0 to 18000. A value
of 0 means that no hello messages are sent.
Usage guidelines
You can set the interval for sending hello messages in IPv6 PIM view or interface view. The configurations
made in IPv6 PIM view are effective on all interfaces, and the configurations made in interface view are
effective on only the current interface. If you set the interval in both IPv6 PIM view and interface view, the
configuration in interface view always takes precedence.
Examples
# Set the interval for sending hello messages to 40 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 pim timer hello 40
Related commands
timer hello (IPv6 PIM view)

ipv6 pim timer join-prune

Use ipv6 pim timer join-prune to set the interval for sending the join/prune messages on an interface.
Use undo ipv6 pim timer join-prune to restore the default.
Syntax
ipv6 pim timer join-prune interval
undo ipv6 pim timer join-prune
Default
The interval for sending the join/prune messages is 60 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
interval: Sets the interval (in seconds) for sending the join/prune messages , in the range of 0 to 18000.
A value of 0 means that no join or prune messages are sent.
175