Crp-Policy (Pim View) - HP 6125XLG Command Reference Manual

priority priority: Specifies a priority for the C-RP, in the range of 0 to 255. The default setting is 192. A
larger value indicates a lower priority.
Usage guidelines
The IP address of a C-RP must be the IP address of a local PIM enabled interface on the C-RP. Otherwise,
the configuration does not take effect.
In an ACL, the source field specifies the multicast group range to which the C-RP is designated, and the
other fields are ignored. If the specified addresses are not multicast addresses, the ACL is not valid. Only
groups that match a permit statement in the ACL are advertised.
If you want a C-RP to provide serviced for multiple multicast group ranges, you can specify them by
multiple permit statements in an ACL and reference the ACL in the group-policy keyword.
If you execute this command using the same C-RP IP address multiple times, the most recent configuration
takes effect.
Examples
# Configure the interface with the IP address of 1.1.1.1 as the C-RP for multicast group ranges
225.1.0.0/16 and 226.2.0.0/16, and set its priority to 10.
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 225.1.0.0 0.0.255.255
[Sysname-acl-basic-2000] rule permit source 226.2.0.0 0.0.255.255
[Sysname-acl-basic-2000] quit
[Sysname] pim
[Sysname-pim] c-rp 1.1.1.1 group-policy 2000 priority 10

crp-policy (PIM view)

Use crp-policy to configure the legal C-RP address range and the multicast group range to which the C-RP
is designated.
Use undo crp-policy to remove the configuration.
Syntax
crp-policy acl-number
undo crp-policy
Default
No restrictions are defined for the legal C-RP address range and the multicast group range to which the
C-RP is designated, and all received C-RP messages are regarded legal.
Views
PIM view
Predefined user roles
network-admin
Parameters
acl-number: Specifies an IPv4 advanced ACL, in the range of 3000 to 3999.
57