Mld-Snooping Source-Deny - HP 6125XLG Command Reference Manual

Use undo mld-snooping router-aging-time to restore the default.
Syntax
mld-snooping router-aging-time interval
undo mld-snooping router-aging-time
Default
The default setting is 260 seconds.
Views
VLAN view
Predefined user roles
network-admin
Parameters
interval: Sets an aging timer (in seconds) for the dynamic router ports in a VLAN, in the range of 1 to
1000.
Usage guidelines
You must enable MLD snooping for a VLAN before you configure this command for the VLAN.
The configuration made in VLAN view is only effective on the current VLAN and takes preference over the
global configuration.
Examples
# Enable MLD snooping for VLAN 2 and set the aging timer for the dynamic router ports in the VLAN to
100 seconds.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping router-aging-time 100
Related commands
• mld-snooping enable
router-aging-time (MLD-snooping view)
•

mld-snooping source-deny

Use mld-snooping source-deny to enable IPv6 multicast source port filtering on the current port to filter
out all the received IPv6 multicast data packets. This allows the port to connect to only IPv6 multicast
receivers rather than to IPv6 multicast sources.
Use undo mld-snooping source-deny to disable IPv6 multicast source port filtering on the current port.
Syntax
mld-snooping source-deny
undo mld-snooping source-deny
116