Ipv6 Pim Timer Graft-Retry; Ipv6 Pim Timer Hello - HP 6125XLG Command Reference Manual

Predefined user roles
network-admin
Examples
# Disable state refresh on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] undo ipv6 pim state-refresh-capable
Related commands
• state-refresh-hoplimit (IPv6 PIM view)
state-refresh-interval (IPv6 PIM view)
•
• state-refresh-rate-limit (IPv6 PIM view)

ipv6 pim timer graft-retry

Use ipv6 pim timer graft-retry to set the graft retry timer.
Use undo ipv6 pim timer graft-retry to restore the default.
Syntax
ipv6 pim timer graft-retry interval
undo ipv6 pim timer graft-retry
Default
The graft retry timer is 3 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
interval: Specifies a graft retry timer (in seconds), in the range of 1 to 65535.
Examples
# Set the graft retry timer to 80 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 pim timer graft-retry 80

ipv6 pim timer hello

Use ipv6 pim timer hello to set the interval for sending hello messages on an interface.
Use undo ipv6 pim timer hello to restore the default.
Syntax
ipv6 pim timer hello interval
174