Display Multicast Rpf-Info - HP 6125XLG Command Reference Manual

display multicast rpf-info

Use display multicast rpf-info to display the RPF information of a multicast source.
Syntax
display multicast rpf-info source-address [ group-address ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
source-address: Specifies a multicast source address.
group-address: Specifies a multicast group address, in the range of 224.0.1.0 to 239.255.255.255.
Examples
# Display the RPF information of multicast source 192.168.1.55.
<Sysname> display multicast rpf-info 192.168.1.55
RPF information about source 192.168.1.55:
RPF interface: Vlan-interface1, RPF neighbor: 10.1.1.1
Referenced route/mask: 192.168.1.0/24
Referenced route type: igp
Route selection rule: preference-preferred
Load splitting rule: disable
Table 15 Command output
Field
RPF neighbor
Referenced route/mask
Referenced route type
Route selection rule
Load splitting rule
Related commands
display multicast forwarding-table
•
display multicast routing-table
•
Description
IP address of the RPF neighbor.
Referenced route and its mask length.
Type of the referenced route:
•
igp—IGP unicast route.
•
egp—EGP unicast route.
•
unicast (direct)—Directly connected unicast route.
•
unicast—Other unicast routes, such as static unicast route.
•
multicast static—Static multicast route.
Rule for RPF route selection, based on the route preference of the routing
protocol or based on the longest prefix match to the destination
address.
Status of the load splitting rule: enabled/disabled.
36