C-Rp (Pim View) - HP 6125XLG Command Reference Manual

mask: Specifies the mask.
hash-length hash-length: Specifies a hash mask length, in the range of 0 to 32. The default setting is 30.
priority priority: Specifies a priority for the C-BSR, in the range of 0 to 255. The default setting is 64. A
larger value indicates a higher priority.
Usage guidelines
The IP address of a C-BSR must be the IP address of a local PIM enabled interface on the C-BSR.
Otherwise, the configuration does not take effect.
If you execute this command for a zone multiple times, the most recent configuration takes effect.
You can configure the same C-BSR for different zones.
Examples
# Configure the interface with the IP address of 1.1.1.1 as the C-BSR for the global-scoped zone.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] c-bsr 1.1.1.1

c-rp (PIM view)

Use c-rp to configure a candidate-RP (C-RP).
Use undo c-rp to remove the configuration of a C-RP.
Syntax
c-rp ip-address [ advertisement-interval adv-interval | group-policy acl-number | holdtime hold-time |
priority priority ] *
undo c-rp ip-address
Default
No C-RPs are configured.
Views
PIM view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the IP address of a C-RP.
advertisement-interval adv-interval: Specifies an interval (in seconds) between two C-RP-Adv messages,
in the range of 1 to 65535. The default value is 60 seconds.
group-policy acl-number: Specifies an IPv4 basic ACL in the range of 2000 to 2999 to filter IPv4
multicast groups. The C-RP is designated only to IPv4 multicast groups that match a permit statement in
the ACL. If the group-policy acl-number option is not specified, or if the specified ACL does not exist or
does not have any valid permit statement, the C-RP is designated to all IPv4 multicast groups
224.0.0.0/4.
holdtime hold-time: Specifies a lifetime (in seconds) for the C-RP, in the range of 1 to 65535. The default
value is 150 seconds.
56