Table of Contents
Advertisement
General Site Requirements
Placement of the System
Network Equipment, Numbers and Addresses
This section describes the requirements your site must meet for the safe
installation and operation of the system.
Place the MGC-25 on a hard, flat surface such as a desktop or mount it on a
rack. For more information, see Chapter 2, "Installing the MGC-25 in a
Rack" on page 2-8.
The airflow of the MGC-25 is from front to back. Be sure that the areas in the
front and back of the system are clear for proper ventilation.
When mounting the system on a rack, always use brackets or a shelf. Never
install the MGC-25 system by only fastening the front screws to the rack.
Obtain the following information from your network administrator:
IP address for the MGC-25
•
Subnet Mask for the MGC-25
•
Default Gateway IP Address (optional)
•
Gatekeeper IP Address, if applicable
•
For ISDN configurations, obtain the following definitions of your equipment
and information from your network service provider:
PRI line(s) or Leased Line(s)
•
Directory number range(s)
•
Switch Type
•
•
Line Coding
•
Line Framing
•
Numbering Plan
•
Numbering Type
If the MGC-25 has to be connected to the public ISDN network, an external
CSU or similar equipment is needed.
Chapter 1 - Before You Begin
1-3
Advertisement
Table of Contents
